SPECIFICATIONS

STRUCTURE

• Fibreglass roving & unidirectional reinforcements over foam floors with limber holes
• Deck flange bolted & bonded to hull flange
  
• Cast lead alloy ballast
• Stainless steel keel bolts in place with stainless steel nuts & washers
• Keel bedded to sump with epoxy
  

HULL CONSTRUCTION

• Vinylester resin throughout
• Single piece Core-Cell cored fibreglass molding
• Extra reinforcing as required
• Core phased out in way of all thru-hulls, struts, shaft log, rudder port & centre line
• Molded keel sump with increased laminate
• Awlgrip painted top sides & boot stripe
• Epoxy bottom barrier coat
• Owner specified bottom paint
• Gold leaf cove stripe & name
• Externally fastened 9,300 lb.cast lead ballast
  

DECK CONSTRUCTION

• Single piece Core-Cell cored fibreglass molding with non-skid pattern on all working surfaces
• Core phased out in way of all deck fittings
• Awlgrip painted deck & non-skid
• Fibreglass storage box in aft deck
• 3 large storage lockers in cockpit
• Varnished teak cabin sides & nosing
  
• Varnished teak cockpit sides & cap
  

DECK HARDWARE

• All winches chromed & self-tailing
  
• 2 primary electric cockpit winches, Lewmar #54
  
• 2 secondary electric cockpit winches, Lewmar #50
• 1 halyard winch, Lewmar #48
  
• 2 cabin top control line winches, Lewmar #44
  
• 2 winch handles, 10" with lock-in
  
• 12 volt dual direction Lewman windlass
  
• 3" foam  upholstered cockpit cushions
  

• All deck hardware Harken or Lewmar
  
• Deck blocks at spar for halyard reefs & control lines
  
• 2 four sheave organizers
  
• 2 inboard genoa tracks
  
• 2 outboard genoa tracks
• 2 opening low lead sheet cars
  
• 2 large snatch blocks
  
• 2 medium snatch blocks
  
• 2 double sheave footblocks

•  All hatches Lewmar polished aluminium
• 1 fore hatch
• 2 vent hatches
• Varnished teak cap rail
• 2 varnished teak handrails on housetop
• 4 varnished teak handrails on deck
• Varnished teak flag pole
• Solid teak vented companionway doors
• Teak slatted cockpit grating
• Large fold-down teak cockpit table with storage
• Flush mounted stanchion bases with removable stanchions & upper lifelines
• Welded stainless steel mast collar
• Welded stainless steel anchor roller

• Four 10" stainless steel mooring cleats
• Two 10" stainless steel cockpit cleats
  
• 4 custom chrome bronze chocks set into rail
• Housetop cleats as required
• Line stoppers as required

ENGINE & DRIVE SYSTEM

• Yanmar 3JH2TCE saildrive, 47 hp. with folding two blade propeller
  
• 50 US gallon aluminium fuel tank with vent
  
• Racor fuel filter
  
• Engine room sound insulation
  
• Blower engine room ventilation
  
• Hinged engine access
  
• Stainless steel thru transom exhaust
  
• Coast guard approved exhaust hoses
  
• Water lift muffler
  

STEERING

• Balanced fibreglass foam filler rudder with stainless steel shaft & stiffeners
• Custom fibreglass pedestal
• 48" diameter stainless steel wheeel with leather wrapping
• 6" Ritchie compass with chromed cap
• Stainless steel emergency tiller
  

PLUMBING

• Pressure water with hot & cold faucets in head & gallery
  
• 6 gallon water heater with 110V & engine heat exchange
  
• Foot pumps for fresh & salt water in galley
  
• 2 stainless steel water tanks, 80 US gallons per, with level gauges
  
• Under mounted deep stainless steel sink in galley
• Icebox drain pump
  
• Rigid colour coded PVC plumbing
  
• Marine manual toilet with 30 gallon stainless steel holding tank
  
• Holding tank overboard discharge & 12V macerator
  
• All sea cocks Marelon
  
• Rule 3500 electric bilge pump with float switch
  
• #10 whale "Gusher" manual bilge pump mounted in cockpit

 REFRIGERATION

• 12 volt Norcold refrigeration
• Molded fibreglass box with 4" foam insulation
  

ACCOMMODATIONS

• Main bulkheads Formica covered marine plywood fibreglassed to hull & deck
• All other bulkheads & faces marine grade plywood fibreglassed to hull & deck
• All exposed interior fibreglass in locker interiors covered with teak, cedar or gelcoat
• All interior joiner work & trimsatin varnished
  
• Varnished teak & holly cabin sole
• Removable overhead panels finished in satin white
  
• Shaped varnished valence hand hold at house site
  
• 5" foam upholstered cushions in main cabin & 6" foam in V berth
• All latches, hinges, catches & pulls brass, bright chrome or stainless steel
  
• Chart table with hinged top
  
• Corian counter tops in galley & heads
  

ELECTRICAL

• All wiring sized & colour coded to ABYC specs.
• Navigation lights on mast head, foredeck & stern light on aft deck
• Steaming, foredeck, masthead & spreader lights on mast
• Light on compass
• 1 x DS115 & 2 x 8D gel cell batteries
• 2 explosion proof master battery selection switches
• 12V D.C. custom distribution panel with 30 amp double pole shore power main breaker, A.C. line voltage meter, polarity indicator
• 110V 30amp Shore power with 50' cord
  
• 110V outlets in galley, head & dinette
• 30 amp battery charger
• 5 chrome overhead lights in galley, dinette, head & forward stowage area
• 3 chrome swivel reading lights in dinette, nav.area & aft bunk
• Directional light at chart table
• All lights "Cantaloupi" or "Danish Cabin"