SPECIFICATIONS

STRUCTURE

• Fibreglass roving & unidirectional reinforcements over foam floors with limber holes
• Deck flange bolted & bonded to hull flange
• High densite foam floors in way of mast & engine beds with extra reinforcement
• Cast lead alloy ballast
• Stainless steel keel bolts cast in place with stainless steel nuts & washers
• Keel bedded to sump with epoxy

HULL CONSTRUCTION

• Vinylester resin throughout
• Single piece vacuum-bagged Core-Cell cored fibreglass molding
• Extra reinforcing as required
• Core phased out in way of all thru-hulls, struts, shaft log, rudder port & centre line
• Molded keel sump with increased laminate
• Painted topsides & boot stripe
• Externally fastened cast lead ballast

DECK CONSTRUCTION

• Single piece Core-Cell cored fibreglass molding with non-skid pattern on all working surfaces
• Core phased out in way of all deck fittings
• Aluminium backup plates on thru deck hardware
• Two-tone Awlgrip & gelcoat finish
• 2 large storage lockers in cockpit
• Varnished teak nosing on house sides & front

COCKPIT

• Large hinged cockpit transom door
• Full width FRP swim platform with swim ladder
• Two sealed & self-draining lockers
• Three sculpted seats for cockpit steering
• Pedestal with angled guard & brake
• Table with folding leaves, grab rails, built-in insulated cooler and waste bin
• Single lever engine controls
• Engine gauges with start & stop switches at both stations
• Teak cockpit grating

WINCHES

• All winches chromed & self-tailing
• Dual direction windlass
• 2 primary electric cockpit winches, Lewmar
  
• 2 secondary electric cockpit winches, Lewmar
  
• 1 halyard winch, Lewmar on mast
• 2 winch handles, 10" with lock-in & holders

TRACKS, LEADS, DECK BLOCKS

• All deck hardware Harken or Lewmar
• Deck blocks at spar for halyard reefs & control lines
• Two 2 sheave organizers
• Inboard genoa tracks
• Main sheet traveller on house top
• 2 low lead sheet cars
• 2 large snatch blocks
• 2 double sheave footblocks
• Shroud & backstay chainplates, custom stainless steel with welded bails, bonded to keel

HATCHES, VENTS, PORTS & RAILS

• All hatches stainless steel
  
• 1 fore hatch
• 8 vent hatches
• 10 opening ports with screens
• Varnished teak cap rail
• 4 stainless steel handrails on cabin top
• 2 stainless steel handrails on pilot housetop
• 2 varnished teak dorade vent boxes with 4" stainless steel cowls
• Varnished teak flag pole
• Custom tempered glass windows in pilothouse
  
• 3 windshield wipers with washers
  
• 1 double rail 11/4" stainless steel bow pulpit
• 1 double rail 11/4" stainless steel stern rail with gate
• 14 stainless steel custom stanchions
• 2 gates with braces & upper lifeline gates
• Upper & lower lifelines vinyl coated 7"X19" stainless steel with turnbuckles
• Welded stainless steel bowsprit with twin anchor rollers
  
• Welded stainless steel bow fitting
• Split anchor locker with deck hatch access and storage
• 2 Cast stainless steel fresh water fills
• 2 Cast stainless steel fuel fills
• 1 Cast stainless steel waste pump out fitting
• 1 Cast stainless steel grey water pump out fitting
• Stainless steel vents for all tanks
• 2 deck scupper drains with screens
• 4 cockpit drains

CLEATS & CHOCKS

• (2) stainless steel forward mooring cleats 14"
• (4) stainless steel midship mooring cleats 14"
• (2) stainless steel aft mooring cleats 14"
• (2) cockpit cleats 10"
• 8 custom stainless steel chocks set into rail
• Line stoppers as required

SPARS & RIGGING

• Awlgrip aluminium mast
• Masthead rig
• Navtec rod rigging
• Schafer genoa furling
• Triple airfoil shaped spreaders
• Double lower shrouds
• Aluminium mast step
• Leisurefurl boom
• Navtec Hydraulic boom vang
• Bobstay
• Inner forestay w/ removable adjuster and running backstays
• Lightning protection
• North Nordac fully battened main sail
• North Nordac 120% Genoa
• North storm jib
• All rope running rigging, colour coded
• 1 mainsheet
• 2 genoa sheets
• 2 main halyards with shackles
• 2 genoa halyards with swivel snap shackles
• Flag & burgee halyards
• 8 fenders and 8 mooring lines

• Balanced fibreglass foam filled rudder with 5" stainless steel shaft & stiffeners
• Fibreglass steering pedestal
• 48" diameter stainless steel wheel
• 6" Ritchie compass with stainless steel cover
• Stainless steel emergency tiller
• Inside steering station with compass, full engine instrument panel, controls & chart area

ENGINE & DRIVE SYSTEM

• John Deere 250 hp. diesel with instument panel
• Bow thruster
• 2 1/2" diameter Aquamet propeller shaft
• 4 blade folding propeller
• FRP shaft log & dripless shaft seal
  
• GROCO raw water engine strainer
• Two 200 US gallon aluminium fuel tanks with vents
• Dual Racor fuel filters with vacuum gauge
• Engine room sound insulation
• Blower engine room ventilation
• Hinged engine access
• Stainless steel thru transom exhaust
• Coast guard approved exhaust hoses
• Waterlift muffler
• Engine spares kits

ACCOMMODATIONS

• Standard finish white bulkheads with satin varnish trim & doors
• Main bulkheads Formica covered marine plywood fibreglassed to hull & deck
•  All other bulkheads & faces marine grade plywood fibreglassed to hull & deck
• All exposed interior fibreglass in locker interiors covered with teak, cedar or gelcoat
• All interior joiner work & trim satin varnished
• Varnished teak & holly sole
• Removable overhead panels finished in satin white
• Shaped varnished valence hand hold at house side
• 5" foam upholstered cushions in main cabin & Tempur matress in staterooms
• All latches, hinges, catches & pulls brass or bright chrome or stainless steel
• Stainless steel sinks in heads
• 2 Separate shower stalls
• Solid surface tops in galley & heads
• Custom dish storage at galley
• Oceanair skyscreens on overhead hatches

REFRIGERATION

• DC refrigeration
• Separate freezer & refrigerator with top & front access
• Molded fibreglass box with 4" foam insulation

PLUMBING

• Pressure water with hot & cold faucets in heads & galley
• 20 gallon water heater with engine heat exchanger
• Shower with molded sump, sump pump & telephone type shower head
• Foot pumps for fresh & salt water in galley
• 2 water tanks, 150 U.S. gallons per with level gauges
• Under mounted double stainless steel sink in galley
• Under mounted stainless steel sinks in heads
• Rigid colour coded PVC plumbing & couplers
• 2 Vacuflush heads with 60 US gallon holding tank with overboard discharge pump
• All below water through-hulls fitted with Marelon seacocks
• Hot and cold cockpit shower
• Fresh and sea water washdowns on foredeck and aft cockpit

BILGE PUMPS

• 3 electric bilge pumps with auto  switches
• manual bilge pump in cockpit
• 
  

PROPANE

• 3 burner stainless steel stove with oven
• Two 20Ib. aluminium propane tanks with regulator
• Propane storage in vented aft locker
• Solenoid propane shutoff valve with remote switch
• All hoses & connections to Coast Guard requirements

EXTERIOR LIGHTS

• Navigation lights on bow pulpit, stern light on stern push pit
• Steaming, foredeck, masthead & spreader lights on mast
• Light at compass locations

INTERIOR LIGHTS

• Overhead dome lights in staterooms, main cabin, galley, heads, pilothouse & engine space
• Directional reading lights in staterooms, main cabin & pilothouse
• All lights "Cantaloupi" or "Danish Cabin"

ELECTRICAL SYSTEM

• All wiring sized & colour coded to ABYC specs.
• (1) x 4D starting battery & (6) x 8D AGM house batteries
• Separate thruster/windlass battery forward
• Battery selection switches
• 24V D.C. and custom distribution panel
• 50 amp. 125/250 volt Shore power with 100' cablemaster cord retractor
• 50 amp shore power main breaker, A.C. line voltage meters, polarity indicator
• 12v outlets through out
• 110 volt outlets in galley, head, dinette & staterooms
  
• Prosine 3000 watt inverter/charger
• 80amp battery charger
  
• 1 x 12,000 BTU and 2 x 20,000 BTU air conditioning units w/ reverse heat
• 12kw generator with sound shield